XC Feed Zone Stand Photos

1. This was the stand in its first testable format - the beech joint at the top will be replaced with the 3D print and a different cage mount will be used to support two cages.

 2. As the 3D printed component was not yet ready, the beech joint was used again, however the cage mount is here and the stand supports both bottles.

 3. An exploded view of the tripod assembly.

4. Close-up of the pin and slot of the height adjust mechanism. The pin slides in the slot and you just lift and twist to set the height of the stand - there a 5 heights.

 5. Another view of the height adjust mechanism

6. The tripod assembly on the workshop floor. Holes for pegs are visible in the feet.

7. The stand supporting two bottles (OK I know they are half full but I can't peg it into ashphalt...) 

8. Close-up of the tipod connector (It's not green, the light was funny)

9. Close-up of the bottle cage mount. The larger hole fits the tube and the cgaes fit in the holes and grooves to stop them from rotating.

10. Cages fitted into the cage mount. 

If you want to see any more photos of different parts of the stand, post a message on XC Racer.

Thanks,

Kim